Dupli-Color Vinyl & Fabric Spray High Performance Red 312g

Dupli-Color® Vinyl & Fabric Coating is perfect for restoring or customizing your interior vinyl seats, dash boards, door panels, shifter boots and consoles. Formulated with a maximum adhesion promoter so there's no need for primer. Dupli-Color Vinyl & Fabric Coating won't crack, peel or chip.

Directions:

1. PREP: Prepare the surface by removing all grease, wax, interior detail product, etc. For best result, use Dupli-Color Grease & Wax Remover to clean the surface. Lightly scuff the surface by using a scuff pad or equivalent. Wipe down the surface again with a grease and wax remover, then let dry. Mask-off surrounding areas to protect from overspray. The recommended application conditions are 55°F (13°C) and 75°F (25°C) with the humidity less than 60%.
2. SHAKE: Shake can vigorously for two minutes after missing ball moves freely and 10 seconds after each minute of use.
3. APPLY: (Optional: Apply 2 light coats of Dupli-Color Adhesion Promoter #CP199 over plastic surfaces for maximum adhesion and protection prior to the colour coat.) To spray, hold can parallel and 8-10 inches from the surface to be painted and use in an even, sweeping motion. Apply 2-3 light coats or until surface is evenly coated. Dries to the touch in 30 minutes and can be handled in 1 hour. Can be recoated at any time.

Additional Information:

• For best results on carpet and seats, vacuum thoroughly before application. Spray surface in one direction with long even strokes. Bursh freshly sprayed carpet with stiff nylon brush to separate fibres. After brushing, immediately spray surface in opposite direction and brush again. Repeat process until smooth, even colour has been obtained.
• Formulated with adhesion promotion to bond interior plastics, vinyl, simulated leather, and to revamp faded and worn surfaces to a like-new finish.
• Ideal for use on automotive dashboards, door panels, centre consoles, trim and seats.
• The EZ Touch Nozzle requires 50% less finger fatigue than a standard nozzle and allows for greater coverage and less overspray.
• After each use, invert can and spray until clear gas comes out.
• If spray button becomes clogged, wear eye protection and wipe off orifice with lacquer thinner. DO NOT stick pins or wire into the can opening. Discard empty can in trash pick-up.
• Covers approximately 12-14 square feet per can.

*This item is considered DG & may incur additional freight charge – Please see our Shipping & Delivery tab for further information.