Dupli-Color Wrinkle Finish Red 312g

Dupli-Color Wrinkle Finish leaves a distinctive custom finish that you can both see and feel. This coating is extremely durable, long-lasting, and chemical resistant. Withstands intermittent temperatures up to 350°F (177°C). Ideal for engine accessory brackets, air cleaner housings and valve covers. Exterior use only.

Directions:

1. PREP: Prepare surface by removing loose paint, dirt, rust, grease, wax, etc. For best results use grease and wax remover to clean surface. Scuff/sand surface with a Red Scotch Brite pad or equivalent until bare metal. Wipe surface down again with grease and wax remover. Mask-off surrounding areas to protect from overspray. Use at temperatures between 60°F (16°C) and 95°F (35°C) and when humidity is less than 60%.
2. SHAKE: Shake can vigorously for one full minute after mixing ball moves freely, Shake can for 10 seconds after each minute of use.
3. APPLY: To spray, hold can parallel and 8-10 inches from surface to be painted and use in ana even, sweeping motion. Apply at least 3 heavy coats in a crosshatch pattern. First coat vertically, second coat horizontally, third coat diagonally allowing 5 minutes between each coat. A relatively heavy film thickness is required for the product to wrinkle. This paint dries very slowly. A “wrinkle” finish does not appear immediately after spraying. Allow 2 hours to air dry. If paint fails to wrinkle or wrinkles in an uneven pattern, apply an additional coat of paint in unwrinkled areas. Although paint appears dry, avoid any contact with surface for at least 24 hours. Allow 38 hours or more before reassembling parts. To cure paint, bake in an oven for one hour at 200°F (93°C). Note that this may cause the wrinkles to be tighter.

Additional Information:

• Formulates a wrinkle finish that you can see and feel.
• Extremely durable, long-lasting, and chemical resistant.
• Withstands intermittent temperatures up to 350°F (177°C).
• Ideal for engine accessory brackets, air cleaner housings and valve covers. Exterior use only.
• The EZ Touch Nozzle requires 50% less finger fatigue than a standard nozzle and allows for greater coverage and less overspray.
• After each use, invert can and spray until clear gas comes out.
• If spray button becomes clogged, wear eye protection and wipe off orifice with lacquer thinner. DO NOT stick pins or wire into the can opening. Discard empty can in trash pick-up.
• Covers approximately 12-14 square feet per can.

*This item is considered DG & may incur additional freight charge – Please see our Shipping & Delivery tab for further information.