INOX-M12 PTFE SUPA GLIDE is a fast drying, resin bonded polytetrafluoroethylene dry film lubricant for the coating of timber, metal, plastic, rubber, glass and most other surfaces.
Made in Australia.
How to Apply:
The surface to be coated must be clean, dry and free of any contaminants such as dust, oil, grease or powder. Information on surface preparation for more critical applications is listed below. Once the surface area has been prepared, spray a liberal coating on the area you want to lubricate and then allow time for the carrier and propellant gas to evaporate. Curing times are listed below.
INOX-mx12 PTFE SUPA GLIDE will cure at room temperature. Coatings are touch dry in about 5 minutes, dry enough to handle in 20-30 minutes depending on the film thickness. Optimum hardness for the best lubrication performance is 2 hours. You have to allow at least 2 hours from application before use. Overnight curing will give the best long term results. High humidity may increase opacity or blush and exposure to strong sunlight may cause darkening, but these will not affect the coating performance.
Pick Up
Unfortunately we currently do not offer customer pick ups
How much does shipping cost?
Shipping is a flat fee of $9.95, there may occasionally be an extra freight charge if items purchased are heavy, bulky or being delivered to a regional or remote location, but we will notify you via email if this occurs
How long will Shipping Take?
Metro Areas
Usually between 1-7 business days since time of order
Rural Areas
Rural areas can take anywhere between 1-10 business days depending on where you are located