VHT High Temperature Caliper Paint Gold 312g

VHT Caliper Paint has been specifically designed for the custom detailing of brake components. It is heat resistant to 900°F (482°C) intermittent and will not chip, crack, fade or rust even under extremes of operation or road and weather conditions. It is easy to apply, dries quickly and is remarkably resistant. Careful preparation is essential.

Directions:

1. PREP: Prepare surface by removing loose paint, dirt, rust, grease, etc. For best results use grease and wax remover to clean surface. Scuff sand surface with 320-grit sandpaper or Red Scotch Brite Pad until bare metal is showing. Wipe surface down again with grease and wax remover. Mask-off surrounding areas to protect from overspray. Use at temperatures between 60°F (15°C) to 85°F (29°C) and when humidity is less than 60%. Do not apply paint in direct sunlight.
2. SHAKE: Shake can vigorously for one full minute after mixing ball moves freely. Shake can for 10 seconds after each minute of use
3. APPLY: To spray, hold can parallel at 8-10 inches from surface to be painted and use in an even, sweeping motion. To avoid runs and sags, apply in 2 light coats, followed by one medium wet coat. Apply all coats within 1 hour, allowing 10 minutes between each coat. For additional coats after 1 hour, wait 7 days for paint to cure. Dries to the touch in 1 hour. Can be handled in 3 hours. Dries to the touch in 1 hour. Can be handled in 3 hours. For added protection apply VHT SP730 Gloss Clear.

Additional Information:

• Provides a customised enhancement to callipers and brake components.
• Heat resistant up to 900°F (482°C) intermittent.
• The EZ Touch Nozzle requires 50% less finger fatigue than a standard nozzle and allows for greater coverage and less overspray.
• After each use, invert can and spray until clear gas comes out.
• If spray button becomes clogged, wear eye protection and wipe off orifice with lacquer thinner. DO NOT stick pins or wire into the can opening. Discard empty can in trash pick-up.
• Covers approximately 12-14 square feet per can.

*This item is considered DG & may incur additional freight charge – Please see our Shipping & Delivery tab for further information.