Dupli-Color High Heat Ceramic Paint Clear 340g

Dupli-Color High Heat Paint with Ceramic is formulated for high temperature applications and is oil and gas resistant. It is ideal for exhaust components, radiator and cooling system components, transmission housing and manifolds, mufflers, boilers, ovens, and slow combustion stoves. Not suitable for BBQ hot plates or food contact surfaces.

Directions:

1. PREP: Sand the surfaces using wire brush or mechanical sander to remove loose paint, dirt, rust, grease, wax, shine etc until sound metal surfaces is established. Solvent clean the metal surface with Mineral Turps or General Purpose Thinners then rinse with a detergent solution or soap and water. Allow the surface to dry thoroughly. Mask-off surrounding areas to protect form overspray. Apply at temperatures between 59°F (15°C) and 86°F (30°C).
2. SHAKE: Shake can vigorously for one full minute or until the mixing ball is rattling freely. Shake can for 10 seconds after each minute of use.
3. APPLY: Hold can parallel at 8-10 inches from surface to be painted and use in an even, sweeping motion across the surface, moving from top to the bottom and overlapping each pass. Allow one minute between coats. Apply several light coats rather than one heavy coat until coverage is achieved. Dries to the touch in 15 minutes and can be recoated after 1 hour. Allow longer drying during cold and wet conditions or where heavy film builds are applied. Hard dry is achieved when the coated surface is heated. Place the coated article in the oven or curing chamber, Set the oven to 392°F (200°C) hold at this temperature for one hour then turn the oven off and allow to cool. The article is now cured.

Additional Information:

• Formulated for high temperature applications.
• Oil and gas resistant.
• Ideal for exhaust components, radiator and cooling system components, transmission housing and manifolds, mufflers, boilers, ovens, and slow combustion stoves.
• Not suitable for BBQ hot plates or food contact surfaces.
• After paint is completely dry, it must be cured to substantially increase the durability of the finish and enhance chemical resistance. Finish is not chemical resistant until cured.
• Coverage is also dependant on application technique, thickness of the applied film and atmosphere conditions.
• Allow longer drying during cold and wet conditions or where heavy film builds are applied. Hard dry is achieved when the coated surface is heated.
• The EZ Touch Nozzle requires 50% less finger fatigue than a standard nozzle and allows for greater coverage and less overspray.
• After each use, invert can and spray until clear gas comes out.
• If spray button becomes clogged, wear eye protection and wipe off orifice with lacquer thinner. DO NOT stick pins or wire into the can opening. Discard empty can in trash pick-up.
• Covers approximately 12-14 square feet per can.

*This item is considered DG & may incur additional freight charge – Please see our Shipping & Delivery tab for further information.